This is requested in order to avoid the necessity of opening a large number of ledger accounts for small items. Registers having but two lamps, controlled by a time limit switch, are wired with the lamps in parallel, in which case the lamp, voltage of each lamp should equal the maximum line voltage. Registers having four lamps are wired with the two lamps on each side in series, in which case the lamp voltage of each lamp should be one-half the maximum line voltage. When the fuse is burned out, the circle on the side will be blackened, thus indicating that new fuse should be put in. Should the register be stopped in its operation by any accidental cause, the fuse will burn out unless the current is turned off at once. When operating register electrically, remove handle and put in its place handle stud collar and replace screw. This is advised to enable the user to become familiar with the various devices and operations as described in this book. This sleeve governs the impression of the back printing cylinder and is regulated by loosening, the screw in clutch R.
This cylinder is carried by a stud having an eccentric sleeve held in position by the clutch R. Place autograph in the right hand with the knurled wheel to the right remove the lock nut at the left end of supply roll by turning TOWARD you. Remove the mechanism by lifting up high enough to clear the pins in the cabinet base. Place the roll of paper on the stud so that end of paper unwinds from the back.ĭo not use any ink except that which is sent with the register or purchased from The National Cash Register Co. Turn knob G until the word off is in correct reading position. Remove plate in front of check paper roll by lifting up and off.
This lever cannot be operated unless the operating handle is in the home position. Unlock register with keys tied to front which are numbered 1, 2, 3, 5, 6 and 8.
0 kommentar(er)
